ALUMINIUM partition with moving lamellas

What is an aluminium partition with moving fins

Balcony and terrace partition in aluminium frame with aluminium fins it's ready aluminium louvre panel intended for building a balcony, terrace, pergola or gazebo. The product is supplied as complete frame with filling, factory-prepared for installation in an external structure.

The frame functions as superstructure - is responsible for the rigidity, stability and correct operation of the entire partition. The aluminium laths form a louvred curtain surface that does not close the space permanently, but allows it to be adjusted.

Movable aluminium slats OpenUp System - control instead of a fixed wall

Applied in the partition movable aluminium slats OpenUp System allow you to adjust the angle of inclination. This allows you to consciously decide how the built-up space behaves.

Adjusting the slats allows:

• control ventilation,
• adjust amount of light,
• amend visibility and level of privacy.

The set angle of the slats remains stable and the entire baffle works predictably even under varying external conditions.

Blind panel (aluminium frame + movable louvres) - a design solution for balcony or terrace

The frame is welded from closed structural aluminium profiles, used in external buildings. As standard, profiles with a cross-section of 60 × 40 mm.*

Such a solution:

• maintains correct frame geometry,
• ensures stable operation of the fins,
• eliminates the „working” effect of loose components,
• allows safe, permanent installation.

The frame is not a finishing frame, but a load-bearing element of the entire development.

Where an aluminium framed partition with fins will work

This baffle variant is used as:

• balcony partition in multi-family housing,
• side terrace cover,
• the side wall of the pergola,
• cover in gazebos and garden structures.

The frame enables the partition to fit aesthetically into the existing structure and maintain a consistent appearance throughout.

Delivery of aluminium louvre panel

You can order a partition collect directly from our premises or order with courier delivery. The product is sent in two packages. One contains the finished frame with screwed-on OpenUp System brackets, the other contains the made-to-measure laths.

Frame assembly and adjustment - what you need to know

The partition should be level and securely fasten to the supporting structure - to the sides, bottom and top. The correct screwing of the frame ensures safe and stable operation of the entire partition.

If the slat adjustment works with resistance after installation, it is possible to correct the setting - e.g. by unbuckling the slats at the joint and readjusting the frame geometry. This allows the operation of the fins to be matched to the actual installation conditions.

Frame partition a kit for self-build of terrace or balcony

The aluminium framed partition with aluminium fins is a ready-to-install panel. Compared to kits assembled from individual components:

• does not require building a frame on site,
• reduces assembly time,
• produces a predictable end result,
• reduces the risk of installation and measurement errors.

It is the solution of choice when orderly assembly and a finished product form are important.

Correct measurement before ordering

The frame is a rigid component, so the installation location must be measured accurately before ordering. Measurements should be taken in three points (bottom, middle, top) and to order accept narrowest dimension. This avoids the situation where the finished frame does not fit into the prepared space.

*The manufacturer allows a dimensional tolerance of up to ±3 mm on the frame profile cross-section.